T&H #WU-25 High Frequency Tube Mill Line 3" (76.2 mm) x .134 (3.40 mm)
Manufacturer: T&H MACHINE
Model Number: WU-25-1

PRELIMINARY SPECIFICATIONS:
Line Direction: Right to Left
Maximum Tube Diameter: 3" (76.2 mm)
Minimum Tube Diameter: 1" (25.4 mm)
Maximum Wall Thickness: .134" (3.40 mm)
Minimum Wall Thickness: .034" (.86 mm)
Maximum Line Speed: 300 FPM, Maximum Gear In Speed, No Load
Maximum D/T Ratio: 60:1
Minimum D/T Ratio: 10:1
Maximum Material Yield: 50,000 PSI
Spindle Diameter: 2-1/2" (63.5 mm)
Roll Space Forming: 12" (304.8 mm)
Roll Space Fin & Sizing: 6-3/4" (171.4 mm)

ENTRY EQUIPMENT:
Jib Crane, 6,000 Lb. Capacity
Double Uncoiler, KENT Model SKD, 10,000 Lb. Capacity
Shear End Welder, KENT Model 10-135
Floop, KENT Model R-227-RE

FORMING MILL:
Entry Guide Table, 4-Roll
(4) Driven Breakdown Stands
(6) Idle Side Rolls
(3) Driven Fin Stands

WELDING SECTION:
No Welder included
Seam Guide Unit
3-Roll Weld Pressure Unit
Coolant Section, Flood Type, 15' Approximate

SIZING MILL:
(3) Driven Sizing Stands
(3) Idle Side Rolls
Straightener, Turkshead 4-Roll

CUT-OFF:
NEW UCG 3" (76.2 mm) High-Speed Flying Cold Saw (Note: New saw will take 10-12 weeks ARO)
USED 20' Runout Table, Single Dump

MILL DRIVE:
(3) 75 H.P., D.C. Motors, 440/60/3
CONTROL TECHNIQUES Mill Controls

TOOLING:
8 sets, Tooling is believed to be complete sets, but suggest customer inspection to confirm.
Sizes Rounds:
50mm, 55mm, 60mm
1.500", 1.750", 2.000", 2.500", 3.000"

APPROXIMATE LENGTH: 115'
APPROXIMATE WIDTH: 15' - 20' 

Ref. No. BPMB6196