2 x 2000 Ton Kurimoto Model C2F-20GW & C2F-GW /TES-60D Hot/Warm Vertical 5-Station Forging presses for Inner and Outer Bearing Races
Built 2008/2012

SPECIFICATIONS:
Built by Kurimoto, Ltd, Osaka, Japan
Capacity 2000ton
Stroke 400mm
Number of strokes 30 – 60min.
Continuous inching: 5 min – 1
Automatic Die height Adj 977mm (stroke down on adj. up)
Slide adjustment 10mm
Max. Part weight 4kgs
Max. Part diameter 180mn
Bolster bottom dimensions (R/L) 1600x (F/R) 1080 x (thickness) 250mm
Bolster top dimensions (R/L) 1600x (F/R) 1080 x (thickness) 150mm
Side opening 1200mm
Distance between columns.2,000mm
Lower Knockout.................Height stroke: 100mm, Diameter: 40mm.
Max. 400kN (total 1Mn x 100mm)
Main Motor.........................268.2HP (200kW)

Including:

Manyo LBS-300 Bar Shear w/auto bar rack and extra cutters, 90mm stroke length, 60spm, overhead crane, load meter, signal tower, Display panel.
Uni-Wash System
Bar Rack & Mitsui 1000kW Induction Heater, 6600 volts, Model HP-PH12-01
Automated NTEC SSP-300I Sizing press for outer rings, built 2012, 200mm length of stroke, Bolster area: 900 x 600mm, Controls with display

FEATURES:
• Load meter with overload sensor
• Revolutionary Stick release device (hydraulic type)
• Automatic 5-Station (3D) servo transfer system
• Bearing temp. detector (8 x locations)
• Guide gib temp. detector (8 x locations)
• Wide range of allowable eccentric loads
• Die holder change device
• Upper die exchange device
• Knockouts
• Oil separator
• Material Feeder
• Strain gauge type load meter w/Digital Display
• Automatic Die Height Adjustment feature
• Smoke extraction system
• Top force changer
• Die holder clamper and lifting device
• Die holder: for top forc
• Die height automatic control unit
• Lubrication cleaning device for press body
• Tool lubrication system
• Flange for Exhaust
• Mitsubishi PLC controls
• Air filtration system
• Spare motor & spare upper and lower bolsters
• Inner, Outer, Web and Bypass conveyors
• Bearing Temperature Sensors at (16) locations
Transfer Machine model TES-60D w/many fine features
• Die Holder Clamper and Lifting Device
For top force - (4) Units for Each press Line
For Bottom Force - (6) Units For Each press Line
Die Lifter One Unit each for RH & LH)
Extra bolsters, Machine parts, oil separator, conveyors
Only small 1.3kg low/medium carbon parts were ever produced on these machines. The presses are capable of going up to 4kgs. They were never abused or used to full capacity or speed.

Ref. No. BPMB51980